How to do copper pour in EagleCAD v7
24,995
Published 2014-08-25
This is part of my magazine article series in Everyday Practical Electronics, November 2014. You can check other videos on my YouTube channel and website mjhdesigns.com. You can also connect with me on twitter at @mikehibbett.
All Comments (7)
-
you helped me thank you
-
very helpful.. thanks
-
awesome, thanks!
-
thanks
-
Just a (noobie) question: what are the steps when designing a layout including a ground pour? I mean... are something like the ones below? 1) route all signal but GND; 2) assign the name "GND" to all remaining ground-pins; 3) add the ground plane and name it "GND"; 4) press the "Ratsnet" button It's something like that?
-
thanks