CONVERTING 4L80E 2WD TO 4WD FOR FREE
49,973
Published 2022-01-18
tools needed
-hand tools
-cut off wheel
-flapper disk
-grinder
-tape measure.
All Comments (21)
-
Saved me a lot money homie thanx
-
hi there, can you say what transfer case that is and what year 4l80 it is? thank you.
-
If I’ve already cut they shaft in my 4L80e like in this video can I still adapt it to a NP205 transfer-case if I’d like to ??
-
Why did you cut anything off the t-case you only needed to shorten the transmission output shaft
-
Can convert a 4x4 700r4 to a 2x4 by changing the tail housing?
-
Got a new subscriber. Good video
-
This worked thank you we were scared at first cause it wouldn’t start then towed it to shop and they said it was a knock sensor or something like that and they changed it .. truck fired right up but wouldn’t move so we doubted it worked… then we forgot it needed fluid so we filled her up and she drives normal again… thank you
-
Which cars have the 4l80 that comes 4x4 stock?? The one used for drag racing with a button to switch from rwd to 4x4
-
I have the same issue need a 4x4 tranny and i got the 2wd at the pick and pull . I wanted to keep the original to the engine and realized i need a 4x4 for my appication. The truck i pulled is a 2008 and wondering if a 2004 4x4 tranny fit with the 2008 computer
-
Basically, If I mod a 4L80e to fit a NP208 transfer case will it be possible to use it with a NP205 transfer case ?
-
Hola funciona también en una transmisión estándar del 2002 se puede convertir a 4x4
-
Will this same technique work on a 4l60e?
-
Curious why you didn't just swap the output shaft cdom.the 4wd in as it's already shorter?
-
Just cut transmission
-
I wanna try this but does this work? I’m asking before I cut
-
You have a list of tools needed but, don't say what type of hand tools I will need for this job? Can I use your flat head screwdriver? :elbowbump:
-
Instead of shortening the t case. Why not take more off the shaft?
-
why did you tip your hat at the end? just curious
-
What transfercase is that?
-
Why not just change shafts?