Toggle Switch Servo Positioner with Speed Control
19,260
Published 2017-03-11
This is the link to the part in my web store:
www.freewebstore.org/heyok-performance/Servo_Posit…
All Comments (21)
-
I have one of these 2 pot versions for my kylo cosplay helmet. works a treat. Just ordered this new speed adjustable version too
-
Interesting video. Since you are knowledgeable in this area, I have a question. I have an, on-off-on toggle switch that I need to control with a typical servo. Currently I am operating it with a 2-56 threaded rod and a clevis, is there something made for this that I'm not aware of. Thanks for any information you may have.
-
Hi can you tell me if you could post this to the UK? Also could you tell me once the servo meets it's end point. Is it still consuming power i.e. is there still a signal being sent?
-
I am not very experienced in this area. Could put a different on/off switch on it. Or does it have to be that one?
-
Is there anyway to hook up two servos to a single controller? I need to have two servos to move in the same way, same time, and this configuration is perfect for what I need.
-
Hey buddy, is there any way you can show how you have the pots wired up? I'm looking to duplicate the exact same thing.
-
Hi. Can i replace the switch you are using with a simple on/off switch ? If not, what is the type of switch needed ? I bought your product but i need to change the switch and i'm lost, there is so many type of switch available on Aliexpress. I don't understand why you are using a 3 pin switch. One last question: Does the battery drain while the motor is not moving ?
-
What is the part called that you was using to control the speed ect? Thanks
-
can you send circuit diagram of position controller use in this video
-
Is there anyway you could show a set up, where you press a tactile and have it spin 180, then when you release it, it spins back?
-
It servo driver i was looking for. Can you pleaseshare me the schematic of that driver my friend. Or even share me the link if it available on internet. Thx
-
Hi, anyway of using a 3 position toggle switch so that it goes left and right and back to neutral?
-
Hi good afternoon could you tell me how much it cost me if I wanted you to produce 20 of these exactly like you do have it in the video above electronics
-
Can you make this servo speed controller use at Rc receiver,?
-
Can you link all the supplies these are exactly what I needed and I cant seem to find them
-
I would like to purchase one of these.
-
it be possible to hook it up to a 12 volt model railway controller
-
Do you have an online store for these?
-
how do you make it
-
Do you still make these?