Myford ml7 lathe. Part13. Tailstock DRO
1,038
Published 2024-06-19
#diy #toolshed #machineshop #metalworks #metalturning #shedwork #digitalreadout
All Comments (14)
-
Well done Andre. The DRO set up looks really good, and when you purchase a mill a DRO on that is a real timesaver.π
-
I like this approach and interesting to watch.
-
π§π§π§π§Great content, new subscriber here, getting ideas from you for when I start to restore my lathe, keep up the good work πππ
-
Nice work Andre! A tailstock DRO would be handy! The only problem I have with those is the simple fact that I forget to turn them off!!
-
good job Andre, I think you`ll wonder how you ever did without it once you start using the scale, same goes for the DRo`s , did similar when I had a Myford, really good add on and I like the sticker collection, makes me think of trying to make one too. Baz. π
-
Never considered putting a dro in my tailstock though I could use one from time to time.
-
ππ
-
π§
-
π§π§π§
-
Hey Rusty , very nice milling . I would like to have a lathe . ππ»
-
π§π§π§π§π§
-
Jy laat my lekker lag. Pa se goed raak ook sommer net weg, en daag dan weer op.
-
Lekker man! Ek moet nog myne doen.