Ender 3 Pro ( modded ) #SpeedBoatRace 10:05

The2mD
The2mD
953
0
Published 2022-01-02
Build some new part cooling solution ( visible at the end ), so another speedbenchy...

at first i increased the speed and acceleration in steps of +10mm/sec / +3000mm³/sec and got respectable results ( 12:28 and 10:56 ) and then i thought YOLO and just uses 200mm/sec ( 25mm³/sec flow ! ) and 25000mm³/sec acceleration expecting it to fail, either because of layer shifting or because of too much flow. i am using a Standard nozzle after all...

turns out the steppers of the ender 3 pro are pretty good. no layer shifting at all, and no clicking extruder either O_O.

the finished Benchy sure isn't pretty but for a Speedbenchy i would say its ok.

Settings:

- PLA Tinmorry Black Matt ( 220C° nozzle / 50°C bed )
- 0.4mm nozzle and 0.5mm line width
- 0.25 layer Hight
- 3 top and bottom layers
- 2 walls
- 10% infill ( line )
- 200mm/sec speeds on everything ( flowrate 25mm³/sec )
- 25000 mm/sec² acceleration
All Comments (5)